Advertisement
Quick Links
TRANSMITTER
PROGRAMMING
GUIDE
YOu NEED TO PROGRAM BOTH TRANSMITTERS AT THE SAME TIME
1. The main harness connector should be disconnected from the siren
control module at this step of the installation
procedure. If it is not,
unplug the connector .
2. Be sure to have both keychain transmitters
in hand, then plug the
main harness connector into the siren control module. You should
hear a short "chirp"
from the siren.
3. Press and hold the arming button on the existing allready
programmed
transmitter
until the siren sounds "one long "chirp".
4. Immediately
press and hold the arming button on the second
transmitter
until the siren sounds one long "chirp".
5. Both transmitters
should now be programmed.
You can test this by
pressing the arming button on each transmitter,
which will result in
the appropriate
" ARMED"
or "DISARMED"
indication
from the
siren.
IMPORT ANT! If only one transmitter
is operating, repeat the
programming
procedure. Once the harness connector is plugged in, you
have only 15 seconds in which to program both transmitters.
This short
time window is required in order to provide a high level of security .
TRXPRG
TRXPRG
Advertisement
