Advertisement
Transmitter Programming Guide
Transmitter Button Functions
The transmitters included in the security system kit are pre-programmed at the factory, with
button # 1 assigned to channel one only. The suggested program arrangement is listed below.
To program channel 2 and 3, please follow the programming instructions listed on pages two
and three of this manual.
Factory Settings for Transmitter Buttons
Button
Button #1
Button #2
Both Buttons
* Some of the more common accessories for these channels are;
AS 9151 Remote Car Starter
AS 9256 Remote Trunk Release Relay
Model APS-92BT-CL
Owner's Manual
Channel
Remote Emergency Panic
1
Door Lock/Unlock (Optional)
2
*(Optional Devices)
3
AS 9154 Remote Garage Door Interface
AS 9153 Remote Window Roll Up
System Function
Remote Arm/Disarm
Pulsed Output
Switched Output
* (Optional Devices)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Audiovox Prestige APS-92BT-CL
Summary of Contents for Audiovox Prestige APS-92BT-CL
- Page 1 Button #2 Both Buttons * Some of the more common accessories for these channels are; AS 9151 Remote Car Starter AS 9256 Remote Trunk Release Relay Model APS-92BT-CL Owner's Manual System Function Remote Arm/Disarm Remote Emergency Panic Door Lock/Unlock (Optional)
- Page 2 These factory programmed settings can be prioritized based on an individual's frequency of use, (i.e. pressing both buttons simultaneously to activate channel 1, arm/disarm etc.) by following the normal programming instructions below. Please note when changing the button sequences of the factory settings, it is necessary to perform steps 5, 9, and 12 three times using "transmitter A", followed by one time using "transmitter B".
- Page 3 6. Move the valet/bypass switch on, then off again. The dash mounted L. E. D. will flash 2 times, and the siren will "chirp" one time, indicating that the system is ready to accept programming for channel 2, or the pulsed ground output for remote trunk release, remote car starter, etc.
- Page 4 BATTERY REPLACEMENT: The transmitter incorporates a small red L.E.D. built into the case. This L.E.D. can be used to indicate battery condition. You will notice a decrease in transmitter range as the battery condition deteriorates. To replace the battery... 1. Remove the transmitter cover by removing the small screw from the back of the transmitter case.
- Page 5 4. Enter total amount enclosed here $ (N.Y. State residents only: Include appropriate state sales tax) 5. Enclose check or money order (do not send cash) payable to: Audiovox Corp. 6. Mail this form and your payment to: ZIP CODE...
- Page 6 Audiovox Corporation 150 Marcus Blvd. Hauppauge, N.Y. 11788 Form No. 128-4855...
Need help?
Do you have a question about the Prestige APS-92BT-CL and is the answer not in the manual?
Questions and answers