Advertisement
Transmitter Programming Guide
This transmitter is designed for use with your upgrade
remote start unit and is programmed by using the remote
start's program switch in combination with the transmitter
button. Although this transmitter can be programmed into
any of the Audiovox remote start and or alarm, remote start
systems, it will offer limited use and should be used for the
remote start upgrade only.
To program this transmitter into your remote start upgrade
unit:
1) Turn the ignition to the on position
2) Press and release the programming switch 3 times
3) Press and hold, for 3 seconds, the button of the transmit-
ter you wish to add until the parking light flashes indicating
the transmitter has been learned.
4) Repeat step 3 for each transmitter up to a total of 4.
Turn the ignition off to exit the program mode.
NOTE: Do not allow more than 15 seconds to lapse between
steps or the program mode will be automatically exited and
you will have to start over.
Model 091BPr
1
128-8707
1 of 2
Advertisement
Table of Contents
Related Manuals for Audiovox PurSuit 091BPr
Summary of Contents for Audiovox PurSuit 091BPr
- Page 1 Although this transmitter can be programmed into any of the Audiovox remote start and or alarm, remote start systems, it will offer limited use and should be used for the remote start upgrade only.
- Page 2 After removing the two #0 point phillips screws shown, pry apart case with the edge of a finger nail or a small common screwdriver. Keep hold of the metal key ring loop to prevent it's loss as it will separate from the transmitter case.
- Page 3 Credit card purchasers can order additional or replacement transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and follow the instructions from the operator interface. © 2009 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-8707 128-8707 3 of 2...
- Page 4 © 2009 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-8707 128-8707 4 of 2...
Need help?
Do you have a question about the PurSuit 091BPr and is the answer not in the manual?
Questions and answers
I have an Audiovox RX14PBL antenna for my 2014 Toyota Rav4 which auto starts the car. When installed I was given a 141PBR key fobs; and recently replaced it. How do I go about programming the this Key Fob?