Step 3 - Connect Speakers; Step 4 - Connect Am Loop Antenna - FUNAI DVA-206LX User Manual

Step 3 - Connect Speakers

1 Make sure the power is turned off to prevent
possible damage to the system.
2 Connect the speakers' wires to the connectors
on the back panel of the DVD system. Be sure to
connect all the speakers' wires to terminals!
3 To insert a speaker wire, press down the thumb
levers, fully insert each tip of the wire into its
connector, and then release the thumb levers to
lock the wire in place.
CAUTION - To prevent damage to
circuits, do not short-circuit the posivite
Note Note Note Note
and negatative speaker output jacks.
M a k e s u r e t h e e x p o s e d t i p s o f e a c h
speaker wire are separated to the distance
that they cannot touch each other after
they are inserted into the connectors.
Do not connect any other speakers or
devices that are not included with this
system.
Left (L)

Step 4 - Connect AM Loop Antenna

1 Assemble the supplied AM loop antenna by
rotating the base and snapping it into place.
2 C o n n e c t t h e t w o w i r e s f r o m t h e A M l o o p
antenna to the AM antenna connector on the
back panel. Press down the thumb levers to
insert each wire, and then release the thumb
levers to lock the wires in place.
Note Note Note Note
Right (R)
12
To prevent noise pickup, keep the AM
loop antenna away from the system and
other components.
AM loop antenna