Jetmaster 600 Installation Instructions Manual

Mark 3 gas coal

Hide thumbs Also See for 600:

Installation instructions

Jetmaster Mark 3 Gas Coal

Table of Contents

Need help?

Do you have a question about the 600 and is the answer not in the manual?

Page 1 Installation instructions Jetmaster Mark 3 Gas Coal...
Page 2: Location Requirements
1. The fireplace construction must be non-combustible wood. It is recommended that the Jetmaster gas log be and in accordance with the current Building Regulations placed in a properly installed Jetmaster Convector for chimney and fireplace intended for solid fuel use.
Page 3: Lighting Instructions
3. In an existing fireplace or Jetmaster firebox (if being 2. Depress the control knob fully and at the same time used), drill a 15mm hole through the right hand side of...
Page 4 Installation instructions Jetmaster Mark 3 Gas Coal Laying the fire • Unpack the coals contained in a clear plastic bag • Lay the coals so that some irregularity to the pile and lay a row of coals on the vermiculite along the back through which the flames may lick,is created.Your aim...
Page 5: Commissioning Procedure
Jetmaster firebox which has been designed to ensure a proper draw and to eliminate emission spillage. 2. Initially the Jetmaster coal fire may burn with a slightly blue flame. After approximately 20 minutes the fire will settle down and burn with a yellow flame.
Page 6 Notes For further information contact Jetmaster Australia 10 Martin Avenue, Arncliffe NSW 2205 T: 02 9597 7222 F: 02 9597 7622 E: sales@jetmaster.com.au W: www.jetmaster.com.au...

600 low 700sh 700d 850 850 low