Installing A Media Card Reader - Dell Dimension 3100 Owner's Manual

Installing a Media Card Reader

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity
from your body before you touch any of your computer's electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 57.
2 Remove the drive panel (see page 74).
3 Remove the Media Card Reader and bracket from its packaging.
4 Gently slide the Media Card Reader (which should not yet be connected to the FlexBay
cable) into place until you hear a click or feel the Media Card Reader is securely installed.
5 Connect the USB cable on the back of the Media Card Reader to the front panel USB
connector on the system board (see page 65).
6 Connect the FlexBay USB cable to the back of the Media Card Reader.
Media Card
Reader
screws
Removing and Installing Parts
89