NEC VERSA FX Manual page 123

Message
CMOS Display Type
Mismatch
CMOS Time and Date Not
Set
Diskette Boot Failure
DMA Error
DMA#1 Error
DMA#2 Error
FDD Controller Failure
HDD Controller Failure
INTR #1 Error
INTR #2 Error
Invalid Boot Diskette
Keyboard is Locked
Unlock It
Keyboard Error
KB/interface Error
Post Error Messages
Resolution
The amount of memory on the system board is different
than the amount in CMOS RAM. Run Setup to reset the
value.
Run Setup to set the time and date.
The boot diskette is corrupt. It cannot be used to boot
the computer. Use another boot disk and follow the on-
screen instructions.
Error in the DMA controller. Contact your NECC service
representative to replace the CMOS battery.
Error in the first DMA channel. Contact your NECC
service representative for service.
Error in the second DMA channel. Contact your NECC
service representative for service.
The BIOS cannot communicate with the floppy disk
controller. Contact your NECC service representative to
check all appropriate connections.
The BIOS cannot communicate with the hard disk drive
controller. Contact your NECC service representative to
check all appropriate connections.
Interrupt channel 1 failed POST. Contact your NECC
service representative for service.
Interrupt channel 2 failed POST. Contact your NECC
service representative for service.
The BIOS can read the diskette in the disk drive, but
cannot boot the computer. Use another boot diskette.
The keyboard lock on the computer is engaged. The
computer must be unlocked to continue.
There is a timing problem with the keyboard. Set the
Keyboard option in Setup to Not Installed to skip the
keyboard POST routines.
There is an error in the keyboard connector. Contact
your NECC representative for service.
Solving System Problems 10-5