Installing Devices In Drive Bays; Customizing Your System - NEC Versa 2500 Series Manual

Firmly grasp the device and pull it away from the sys-
5.
tem. Each device has a depression marked with a direc-
tion icon,
NOTE
moving the device, the device casing catches.

Installing Devices in Drive Bays

Use the following steps to install a device in a drive bay.
Your system must be powered off before removing or in-
serting devices in drive bays.
Verify that system power is turned off and the LCD
1.
panel is closed. Turn the system upside down.
Align the device in the bay you plan to use. Push the
2.
device into the bay until it locks into place.
Turn the system over, open the LCD panel (if needed),
3.
and power on the system.

Customizing Your System

It's easy to customize your NEC Versa 2500 Series system
using the drive bays. You can work with AC power and
have the diskette drive installed. If you need additional bat-
tery power, you can remove the diskette drive and plug in
an optional second battery pack. Do so as follows:
1. Remove the standard diskette drive or CD-ROM reader
from the drive bay as described in the previous section.
Align the option with the drive bay opening and push it
2.
in until the option clicks into place.
Turn the system over and power on.
3.
for easy removal
))>,
If you release the latch before completely re-
Using Your NEC Versa Computer 4-11
.