Leds - NEC VERSA 2000 Service And Reference Manual

Table Section 2-2 Control and Switch Functions
Control
Reset Switch
Power Switch
Keyboard Select Switch
Power Management
Suspend/Resume
Contrast Control
Brightness Control

LEDs

The NEC Versa 2000 uses LEDs to let the user determine system status. The following list
describes LEDs.
Hard Disk — Green when the system is writing data to or retrieving from the system's hard
disk.
Diskette — Green when the system is writing data to or retrieving from the diskette in the
A drive.
Power Management — Green when power management is in use. No color when power
management is off. Blinking green when the system is in Suspend mode.
Function
Resets the system if the NEC Versa does not respond to keyboard input
or VersaGlide movement. Use this control before powering down the
system and restarting it.
Turns the system on when pushed to the right. Turns the system off
when pushed to the right again.
When on, selects the U.S. keyboard. When off, selects the United
Kingdom, German Keyboard. The switch is located in the memory
compartment on the bottom of the system.
Turns Power Management on when pushed to the right. Turns Power
Management off when pushed to the right again.
Slide the switch for Suspend mode, slide again to resume active mode.
Adjust the dark/light background on the LCD using this switch (on DSTN
models only).
Move the control upward to increase brightness on the LCD. Lower the
control to decrease brightness on the LCD. A brighter adjustment uses
more battery power. For longer battery life, decrease the brightness.