Using A Password; Dual Password Security - NEC POWERMATE ENTERPRISE - 09-1997 Manual

Using a Password

After you set your password in Setup and reboot the
system, a password prompt appears each time you power on
the system.
To use your password, type the password at the password
prompt and press
NOTE
appear on your screen. Enter your password
carefully.
If you enter the password incorrectly, your system does not
boot. You have three chances to enter the correct password.
After the third unsuccessful attempt, you must reboot your
system and try again.
NOTE
the password by setting a jumper on the system
board (see "Clearing Your Password" in Chapter 6).
Once you clear the password, you can boot your
system and set a new password in Setup.

Dual Password Security

Dual password security provides two levels of password
security. A supervisor password allows access to the
system's Setup utility for system configuration. A user
password allows system boot-up only after the entry of a
password.
4-20 Using Tools and Utilities
.
Enter
For security, the characters you enter do not
If you forget your password, you must clear