Table of Contents
Advertisement
Quick Links
IL - (847) 841-7867
INSTALLATION, SERVICE & PARTS MANUAL
860 Church Rd Elgin, IL 60123
330 Mill Bay South Suite 1511
IL - (847) 841-7867
Distributed by Pump Supply Inc
CP4NC
PLEASE FILL OUT THE START-UP REPORT/WARRANTY
REGISTRATION ON THE LAST PAGE
**REPORTS THAT ARE NOT RETURNED CAN DELAY OR
Illinois Location:
(847) 841-7867
Minnesota Location:
(651) 758-7867
Afton, MN 55001
PumpSupplyInc.com
4.5, 7.5, 11.3 & 15HP
VOID THE WARRANTY**
CP4NC4524, CP4NC4534,
CP4NC4544, CP4NC4564,
CP4NC4564, CP4NC7524,
CP4NC7534, CP4NC7544,
CP4NC7564, CP4NC11334,
CP4NC11344, CP4NC11364,
CP4NC15034, CP4NC15044
1750RPM, 60Hz
PumpSupplyInc.com
Submersible Non-Clog
No: CP4NC - 04/15
MN - (651) 758-7867
1
MN - (651) 758-7867
Advertisement
Table of Contents
Related Manuals for Champion Pump CP4NCH
Summary of Contents for Champion Pump CP4NCH
- Page 1 IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 CP4NC 4.5, 7.5, 11.3 & 15HP Submersible Non-Clog No: CP4NC - 04/15 INSTALLATION, SERVICE & PARTS MANUAL PLEASE FILL OUT THE START-UP REPORT/WARRANTY REGISTRATION ON THE LAST PAGE **REPORTS THAT ARE NOT RETURNED CAN DELAY OR VOID THE WARRANTY** CP4NC4524, CP4NC4534,...
-
Page 2: General Safety Information
Keep clear of suction property damage. Each Champion pump is working on a used pump or piping. Never and discharge individually factory tested to insure proper enter a basin after it has been used. - Page 3 IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Specifi cations DISCHARGE 4” 125 lb., Flange Horizontal LIQUID TEMPERATURE 104°F Continuous MOTOR HOUSING Cast Iron, Class 30 VOLUTE Cast Iron, Class 30 2 vane open type with pump out vanes on back IMPELLER side, Dynamically balanced, ISO G6.3, Cast Iron, Class 30...
-
Page 4: Specifications And Dimensions
IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Specifi cations & Dimensions NEMA Locked Full Load Cord Cord Cord O.D MODEL Volt/PH Start Rotor (Nom) Amps Size Type inch Code Amps CP4NC4524 230/1 1750 26.0 59.0 10/4 0.750... - Page 5 IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Performance Illinois Location: (847) 841-7867 860 Church Rd Elgin, IL 60123 Minnesota Location: (651) 758-7867 330 Mill Bay South Suite 1511 Afton, MN 55001 PumpSupplyInc.com IL - (847) 841-7867 PumpSupplyInc.com MN - (651) 758-7867...
-
Page 6: Receiving And Installation
IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Receiving & Installation Receiving Inspection Installation Liquid Level Controls Upon receiving the pump, it should be These pumps are recommended for The level control(s) should be mounted inspected for damage or shortages. -
Page 7: Installation & Service
IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Installation & Service IMPORTANT ! - The overload will then IF A MOISTURE DETECT HAS Name Plate - Record the information automatically reset and start the pump OCCURRED MAINTENANCE SHOULD from the pump name plate to up after the motor cools to a safe... - Page 8 IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Service With a flashlight, visually inspect the oil Apply thread locking compound to cap in the motor housing (3) to make sure screws (6) and place into holes and torque it is clean and clear, light amber in color to 15 ft/lbs.
- Page 9 IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Service Diaphragm - with seal plate (20) Reassembly Position upper motor end bell aligning removed, examine diaphragm (21) for holes and thread cap screws into bearing Bearings - Replace bearings, being ruptures or crackes.
- Page 10 IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Service Be sure the stationary members are in Place seal plate (20) over shaft onto Torque gland nuts to 15 ft./lbs. to prevent bearing bracket (16), being careful not straight and that the rubber ring is not leakage.
- Page 11 IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Service SINGLE PHASE 230 VOLT AC THREE PHASE 460 VOLT AC MOISTURE & TEMPERATURE SENSORS Capacitor/Relay Pack For Control Panels Power Cable Motor Lead Number Control Cable Lead Number For CP4NC4524 &...
-
Page 12: Repair Parts
IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Repair Parts For Repair Part Please supply: Model Number and MFG Date as shown on Name Plate, and Part Description and Part Number as shown on Parts List. Figure 6 IL - (847) 841-7867 PumpSupplyInc.com... -
Page 13: Parts List
IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Parts List For Repair Part Please supply: Model Number and MFG Date as shown on Name Plate, and Part Description and Part Number as shown on Parts List. Ref. - Page 14 IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Parts List For Repair Part Please supply: Model Number and MFG Date as shown on Name Plate, and Part Description and Part Number as shown on Parts List. Ref.
-
Page 15: Troubleshooting Chart
IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 Trouble Shooting Chart Risk of electric shock. Always disconnect the pump from the power source before handling inspections or repairs. Symptom Possible Cause(s) Corrective Action 1. Poor electrical connection, blown fuse, tripped 1. -
Page 16: Limited Warranty
IL - (847) 841-7867 Distributed by Pump Supply Inc MN - (651) 758-7867 LIMITED WARRANTY Manufacturer warrants, to the immediate purchaser and subsequent initial owner during the warranty period, every new pump to be free from defects in material and workmanship under normal use and service, when properly used and maintained, for a period of eighteen (18) months from date of manufacture or twelve (12) months from date of installation (which ever comes fi rst). - Page 17 Start-Up Report / Warranty Registration Please fill out the following questions as completely and accurate as possible. Please mail to Champion Pump Company, Inc. – P. O. Box 528 – Ashland, OH 44805. REPORTS THAT ARE NOT RETURNED CAN DELAY OR VOID WARRANTY.
Need help?
Do you have a question about the CP4NCH and is the answer not in the manual?
Questions and answers