Important! NEVER TOUCH YOUR HEATER OR ITS CASING WITH WET HANDS! DO NOT COVER THE HEATER! When using any electrical device, be sure to follow basic safety precautions, such as the instructions in this instruction manual. General safety instructions PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE ...
Page 3
Always place the unit on a stable, level surface and use it in an upright position. Do not operate the unit in areas where gasoline, paint or other flammable liquids may be used or stored. For indoor use only. ...
Page 4
supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance. CAUTION —...
Page 5
an external switch, such as a timer, or be connected to a circuit which is regularly switched on and off by the electricity supplier. The appliance must not be disposed of with household waste; it must be brought to a local center for the recovery and recycling of electrical appliances.
Description of symbols Complies with European regulations applying to the product. WARNING: In order to avoid overheating, do not cover the heater. Electrical products should not be disposed of with household waste. Please recycle them at the collection points provided for this purpose. Contact the local authorities or your dealer for recycling advice.
Wall Mounted Installation IMPORTANT! Make sure that there is no electrical wiring or other installation (water pipe for example) near the locations where the holes will be drilled. Be sure to fix the unit vertically and firmly to the wall. This appliance is intended for indoor installation and use only.
3. The hook racks are pre-assembled on the back of the heater. Hang the top two hook racks on the screws as picture (Fig 3). Mark the two bottom hook racks’ position on the wall and take away the heater, then drill bottom two holes(Φ8) on the wall and put expansion screw’s plastic cover in the holes as picture (Fig 3).
4. Week program: Running according to your program setting. 5. Device control: When you set on product, the APP will change to device control mode. Set 24 hours timer Set open window function on/off Set week programs’ running date, time and temperature. ...
Press button to set temperature, the temperature will increase or decrease by 1℃ after each pressing. It will show setting temperature on display after setting. Timer: Press button, “00” flash on display, then press button to set timer. Each pressing is 1 hour.
Maintenance ALWAYS isolate the unit from the power supply and let it cool before any maintenance. Clean the unit at least once a year with a vacuum cleaner to remove any dust from the heap. Clean the outside of the device by wiping with a damp cloth and drying with a dry cloth. Never ...
Page 12
Information requirment for the electric local space heaters Reference (s) of the model : ESRR048W/ESRR048A Item Symbol Value Unit Item Unit Type of heat input, for electric storage local space Heat output heaters only (select one) manual heat charge control, with integrated Nominal heat output thermostat manual heat charge control with room...
Page 13
Reference (s) of the model : ESRR064W/ESRR064A Item Symbol Value Unit Item Unit Type of heat input, for electric storage local space Heat output heaters only (select one) manual heat charge control, with integrated Nominal heat output thermostat manual heat charge control with room Minimum heat output (indicative) and/or outdoor temperature feedback...
Page 14
Reference (s) of the model : ESRR080W/ESRR080A Item Symbol Value Unit Item Unit Type of heat input, for electric storage local space Heat output heaters only (select one) manual heat charge control, with integrated Nominal heat output thermostat manual heat charge control with room Minimum heat output (indicative) and/or outdoor temperature feedback...
Need help?
Do you have a question about the SERRE ESRR048W and is the answer not in the manual?
Questions and answers