Reina ARNAGE DE-ARG0805 Installation Manual

Towel rail

AR N A GE TOWE L R A IL

IN STA LLATION GU ID E

Please read these instructions carefully before instalation and operation

1.This Towel Rail is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision or instruction concerning

use of the Towel Rail by a person responsible for their safety.

2.In order to avoid a hazard, this Towel Rail must be installed so that the bottom

rail is at least 600mm above the floor.

3.This Towel Rail is intended to warm and dry towels and therefore is hot to the

touch.

4.The towel rail is to be installed so that switches and other controls cannot be

touched by a person in the bath or shower.

5.To avoid a hazard this towel rail must not be used to hold towels or any other

articles that have been in contact with oil, petroleum based products or dry

cleaning fluids.

6.Use this Towel Rail only with the voltage specified on the rating label.

7.Do not immerse in liquid or allow liquid to run into the interior of the Towel

Rail. Indoor use only.

8.Do not operate this towel rail if damaged or after the Towel Rail malfunctions

or has been dropped or damaged in any manner. Return to a qualified electrical

person for examination, electrical service or repair.

9.Use this Towel Rail only as described in this manual. Any other use is not

recommended by the manufacturer and may cause fire, electrical shock or

injury.

10. Do not use this Towel Rail in a window as rain may cause electric shock.

Table of Contents

Need help?

Do you have a question about the ARNAGE DE-ARG0805 and is the answer not in the manual?

Page 1 AR N A GE TOWE L R A IL IN STA LLATION GU ID E Please read these instructions carefully before instalation and operation 1.This Towel Rail is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the Towel Rail by a person responsible for their safety.
Page 2 TOOLS REQUIED Step 1 Fix 3 mounting single hole tubes to the Pencil threaded holes on the vertical bar, Hammer Screw down the mounting screw with a Measuring Tape screwdriver. Spirit level Electric drill Screw driver Step 2 Hex key Guide the electrical cord through the ACCESSORIES electrical connection two holes mount-...
Page 3 Step 7 Be sure to drill a hole for the core cable going from the leg to the wall on the right lower mounting leg. Connect the core wire from the leg to the power wire inside the wall Step 5 Step 8 Use a hammer to knock plastic wall anchor into wall completely...
Page 4 How to use the TIMER on the towel rail? TIMER working mode : 1)Consistant 24 hours ON 2)2H: 2 hours ON,stop working automatically after 2 hours 3)4H: 4 hours ON,stop working automatically after 2 hours 4)A2( Automatic working mode),2 hours ON,2 hours OFF,then 2 hours ON and 2 hours OFF automatically working as circulation way.

Arnage de-arg1205