Classified
NOTE: This equipment has been tested and found to comply with the limits for a Class digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is li ely to cause harmful interference,
in which case the user will be required to correct the interference at his own expense.
1. Photo sensor and wall switch functions are only available for general light mode, photo sensor function is factory's default
setting. During emergency mode these functions are not available.
2. In photo sensor mode, if ambient luminance < 10Lux, fixture will be turned on automatically, and if ambient luminance
> 30Lux, fixture will be turned off.
3. In wall switch mode, make a wall switch between 1 and 2.
4. Remove the jumper cable to get non-maintain (emergency only) function.
5. 4000K color temperature is factory's default setting, change the pin jumper position to obtain different color temperature.
6. -30°C ~ 50°C ambient temperature is factory's default setting.
7. The battery pack assembly contains the battery, heater pad and thermal protection. If necessary,
please contact the manufacturer to replace it. If the pack scrapping in further, please separate them.
A
page 2 of 5
F.1
K
Need help?
Do you have a question about the CHLORIDE ARC-ACEM and is the answer not in the manual?