Table of Contents
Advertisement
M
N
AKING
ETWORK
Figure 4-2. Making Twisted-Pair Connections
2. If the device is a network card and the TigerStack is in the wiring
closet, attach the other end of the cable segment to a modular wall
outlet that is connected to the wiring closet (see "Wiring Closet
Connections" on the next page). Otherwise, attach the other end to
the port on the 1000BASE-T module.
Make sure the twisted pair cable does not exceed 100 meters (328 ft.) in
length.
Note: When connected to a shared collision domain (such as a hub
3. As the connection is made, the green Activity LED (on the
TigerStack) corresponding to the module port will start to flash,
indicating that the connection is valid and traffic is passing through the
port.
4-6
C
ONNECTIONS
with multiple workstations), switch ports must be set to
half-duplex mode and back pressure flow control disabled.
Advertisement
Table of Contents
