Table of Contents
Advertisement
A
T
BOUT THE
IGER
Module Slots
The switch provides two slots for optional media extender modules. The
slot on the front panel, labeled "M1," supports fiber optic modules with
one 100BASE-FX port. The slot on the rear panel, labeled "M2," supports
modules with one 1000BASE-X port.
See "Optional Media Extender Modules" on page 1-5 for more details on
the available modules.
LED Indicators
The LEDs, which are located on the front panel for easy viewing, are
shown below and described in the following table
LED
LK/ACT
SPD
LK
RX
*If a 1000BASE-X module is installed in slot M2 and has a valid link on its port,
the front-panel 1000BASE-T port is disabled.
1-4
S
10/100
WITCH
2
2
CPU
BC STM
BC STM
PWR
1
Port Status LEDs
Condition
On Green
Flashing Green
Off
On Green
Off
On
On
M2
4
4
6
8
LK
LK/ACT
SPD
RX
LK/ACT
SPD
M1
3
5
7
Port has a valid network connection.
Indicates network activity on the port.
Port does not have a valid connection.
Port 1-8 or M1 is operating at 100 Mbps.
Port 1-8 is operating at 10 Mbps.
Slot M2* module port has a valid connection.
Slot M2* module port is receiving data.
Status
Advertisement
Table of Contents
