Miniatures 52018 Step By Step Assembly Instructions

#52018/92018 Three Gables
House Dollhouse Kit
Step-by-step assembly instructions
Copyright miniatures.com 2018, 2024
MDF PARTS:
Floor
Front wall
Back wall
Right wall
Left wall
Right roof
Left roof
Right roof fixed panel
Front Roof Panel
Porch wall
Small gable right roof
Loft partition wall
Door wall
Floor loft/Porch ceiling
Porch roof supports (2)
Porch foundations (2)
Right roof support
Ridge beam
Gable shelf
WHITEWOOD PARTS:
Porch posts
Door
Vent
Skylight
Windows (8)
Interior trim for door and windows
SUPPLIES NEEDED:
Masking tape
White glue (such as #1249 Weldbond)
Ruler
Pencil
Assembly Instructions
Tip: Plan the finishes for the interior and exterior at the
dry-fit stage, before final/permanent assembly. It is easier
to finish the panels as flat surfaces. Disassemble and finish
as desired, then reassemble using glue.
Separate the MDF floor, main walls and roof pieces from the
smaller pieces. Set aside the door/windows/skylight and their
interior trim package. "Left" and "right" are as if the viewer is
looking at the front of the house.
Structure Assembly
1. Find the two porch foundation pieces (short lengths of
square MDF with a 45º angle at one end). Glue the angled
ends together to make a right-angle section. This will not
2388 Pleasantdale Road, Atlanta, GA 30340 • 1.800.926.6464 • www.miniatures.com • Made in Thailand
GENERAL INSTRUCTIONS
• Identify and inspect all parts using the Parts List.
• Thoroughly read the directions before starting.
• Set up a dedicated work area to avoid the need to unpack,
repack, or move the project frequently.
• Use a clean, level, and dry work surface protected from glue spills.
• Dry fit the parts using masking tape to ensure everything aligns
correctly before permanent assembly.
need to be disassembled for finishing. Tape the joint
together while the glue dries.
2. On the work surface, stand the left wall and back wall
upright, grooves facing inward. Fit the corner together
and secure with masking tape. Tip this assembly down
onto the back wall and fit the floor panel (grooves up
and at the front) into the wall grooves. Fit the right wall
into place and secure the corner with masking tape.
Stand the house upright.
3. Fit the front wall into place and secure the corner with
masking tape. Fit the door wall into place (it can go either
way) and secure the corner (where it joins the right wall)
WARNING:
Not Suitable for Children
under 15 years old.
CHOKING HAZARD — Small parts
1024