FOUNTAINS.COM 4410F1 Setup Instructions

SET UP INSTRUCTIONS FOR 4410F1 - 4417F1
1) Set your fountain on your chosen location and position it
toward your preferred viewing direction.
2) Place the pump and light in the fountain floor. The pump
should be closest to the back wall and the light should be
out in front, aiming back at the middle of the high
fountain wall.
3) Push both power cords out the floor's corner hole.
Open the split rubber stopper and place each cord
inside one of the slit-holes. (The hole for the
pump cord should be a little wider than the hole
for the light cord.) Then push the stopper firmly
into place to create a watertight fountain.
4) Thread the adapter into the bottom face of the
fountain as shown and push the exhaust fitting
firmly into the pump.
5) Place the restrictor clamp onto the middle of the
water tube and tighten just enough to hold in
place. (Later, once you turn your fountain on,
you can tighten this if you wish to reduce the
water flow.)
6) Push the tubing onto the adapter and the pump
exhaust.
7) Push the short copper tube into place over the
exposed black barbed fitting cast into the upper
front of the fountain wall as shown (if it is not
already installed).
8) Read your pump and light instructions. Then
connect the plug / transformer to your power
source to see the fountain run. If your pump does
not produce flow immediately, there may be an "air lock"
Make sure to place your fountain on a firm
area which will not settle. Note: Always
follow local electrical codes and use a
110V GFCI protected outlet.