Page 1
FT-106 Powys Fountain Assembly Instructions Fountain Information: • This fountain holds approximately 2 gallons of water. • This fountain uses a small fountain cover: FTNCOV-SM • No rell device or submersible lights are suggested or this ountain. Pump Information: WP450LV - 120 GPH Low Voltage Pump (16 ft. cord length)
Page 2
FT-106 Powys Fountain Assembly Instructions Fountain Set-Up: Assembly & Installation - A ountain can be dicult to install without knowing and understanding the steps involved. To ensure your ountain is installed properly, please read our instructions and tips beore you begin.
Page 3
FT-106 Powys Fountain Assembly Instructions Step 6 - Place the pump cover (FT-106C) over the pump. FT-106C (3 lbs) 5.25"W x 2"H Step 7 - Use a hose clamp to attach the loose end o the tubing onto the bottom o the water feature (FT-106A).
Page 4
Maintenance: Pump Care - The ountain relies heavily on the quality o the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is ully submerged at all times to avoid damage. Step 2 - Ensure water level is sufcient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.