Switching On/Off; Tft Monitor - VDO MS 6200 Owner's Manual

8

Switching on/off

To switch on the unit:
☞
Press the l POWER button on the TFT monitor.
To switch off the unit:
☞
Press and hold down the l POWER button on the TFT monitor, or
☞
switch off the ignition.

TFT monitor

■
Opening and closing the monitor
☞
Press the F button on the TFT monitor to open or close the monitor.
■
Setting the viewing angle
The viewing angle of the TFT monitor can be set as follows:
☞
Press and hold down the F button until the desired viewing angle is attained,
or:
☞
set the desired viewing angle using the "Screen Tilt" option in the setup menu. See
"Setup menu".
✎
If the Auto Open function is activated ("AUTO OPEN ON"), the monitor returns to the
vertical position after being switched off. The viewing angle originally selected is restored
after the monitor is switched on again.
■
Auto Open function
The Auto Open function lets you automatically control the opening and closing of the TFT
monitor when switching the unit on/off.
For information on these settings, see "Setup menu".
■
Monitor mechanism
If there is an object blocking the path of the TFT monitor as it is extending, a protective cir-
cuit automatically stops the monitor from extending any further.
☞
In this case, press the F button on the TFT monitor or switch the unit off and then on
again.
■
Setting the display parameters (OSD menu)
☞
Press and hold down the NAV button on the TFT monitor until the OSD menu for the display
parameters appears.
☞
Select the desired parameter using the 8 or 2 buttons on the remote control.
☞
Set the values using the VOL– and VOL+ buttons on the TFT monitor or the 4 or 6 buttons
on the remote control.
✎
For the radio, DVD, SD card reader, iPod, Bluetooth and NAV sources, only the "BRIGHT"
parameter (brightness) can be set.
Operation