Table of Contents
Advertisement
INFRARED REMOTE CONTROL
Infrared remote control is included in
this set.
• Preparing the Remote Control
Inserting the Batteries
1. Open the battery compartment
cover.
2. Insert the new batteries. Make sure
that the positive and negative
terminals of the batteries are
oriented indicated.
3. Close the cover.
Battery: AAA size.
• Using the Remote Control
Face the remote control towards the
player front face IR mark (remote
control signal receiver).
Operation angle: About ±30 degree in
each the direction of the front of the IR
mark.
CLOCK FUNCTION
You can select either manual setting or
automatic update of the clock via RDS
Radio signal.
- Manual clock
Go to SETUP mode,
select "CLOCK ON"
Note:
You can select 12 or 24 hour clock
display.
- RDS clock (auto update)
Go to SETUP mode,
select "RDS CLOCK"
Note:
The transmitted time via RDS can
be incorrect.
LINE OUT
You can connect a 2 channels power
amplifier to this set with the RCA cable.
- connect red socket to right channel.
- connect white socket to left channel.
20
AUX IN
You can connect the audio output of
auxiliary equipment to the headunit via
RCA cables.
- connect red socket to right channel.
- connect white socket to left channel.
Go to SETUP mode, turn ON the Aux-In
Select the SRC button (12) to Aux-In.
SMART MODE FUNCTION
SMART mode gives you the great
pleasure of listening to radio from front
speakers, and at the same time playing
the disc source (CD/MP3/VCD/DVD) via
Audio/Video RCA output jacks.
In DVD MODE, long press SMART button
on the unit or SMART button on the
remote control shortly during disc
playback to activate SMART MODE
function. "SMART" appears on the display
of the DVD unit. When press SOURCE
button to switch to radio or AV IN mode,
the front speakers will output the
corresponding radio audio signal or audio
signal of the AV source and the rear
speaks will be muted. In any mode (radio
or AV IN), the DVD disc is playing the
video and audio out jacks output the video
signal of DVD all the while.
Note:
SMART mode can only be turned ON/
OFF in disc-mode.
RESET
Should the radio or CD audio/MP3/VCD/
DVD do not function properly. Press the
RESET button (25) to re-innitialise the
headunit to factory default setting.
Headunit should get back to correct
function.
Advertisement
Table of Contents
