Radio Operation; Rds (Radio Data System) Operation - VDO DV 1805 MP3 User Manual

RESET
RESET button (25) is placed on the front
panel and must be activated with either a
ball point pen or thin hard object.
The RESET button (25) is to be activated
for the following reasons:
- All the function buttons do not operate.
- Error symbol on the display.
Note: Pressing the RESET button (25)
will erase your stored stations in the
memory.
SOURCE
Press button (12) to switch between Disc,
Radio and Aux-In.
MUTE
Press volume button (2) to silence the
receiver. Press it again to resume
listening.

RADIO OPERATION

BAND SELECTION
At tuner mode, press BND button (4)
shortly to select the desired band. The
reception band will change in the following
order:
FM1 FM2 FM3
STATION SELECTION
Press button (10) or
shortly to activate automatic seek
function.
Press for 2 seconds till "MANUAL"
appeared on the display, the manual to
activate the manual mode. If both buttons
have not pressed for several seconds,
they will retune to seek tuning mode and
get back automatic seek function.
AUTOSTORE
- Automatic Memory Storing
Press AST (23), the radio searches for
6 strongest stations and stores them into
the presets of the current selected band.
Note: Any stations that were previously
stored in this memory bank are replaced
by the new stations.
MW1 LW
MW2
button (11)
FREQ SCAN
Press up/down buttons (13/14) shortly
to scan all frequency throughout the
entire band.
Note: SCAN in SETUP mode has to be
turned on before it can function.
STATION STORE AND RECALL
Press any one of the preset buttons
(1 to 6) to recall a station which had been
stored in the memory. Press a preset
button for 2 seconds, previous preset
station can be overwritten by current
tuned frequency.
RDS (RADIO DATA SYSTEM)
OPERATION
The RDS data are the PI, PS, TP, PTY,
TA and AF data.
PI: Program Identification Code
Code for identifying program
PS: Program Service Name
Broadcast station name data
expressed in alphanumerically
character
TP: Traffic Program Identification
Identification data for traffic
information broadcasting station
TA: Traffic Announcement Identification
Identification data showing traffic
information is being transmitted
or not
AF: Alternative Frequencies
Frequency list of broadcasting
station transmitting the same
program
Setting AF Mode
- Press AF button (7)
briefly to switch on/off AF mode.
- Whenever AF is switched on, Symbol
"AF" appears on the display.
- The tuner will return to Alternative
Frequencies whenever the reception
signals getting worse.
- ALARM will be displayed when an
emergency broadcasting is r eceived;
meanwhile sound output level will be
adjusted to the preset output level
automatically when the volume contr ol
is set at minimum.
11