Advertisement
For Canada only Distributed by: | ![]() |
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
If the instruction manual is damaged or if you no longer have the instruction manual in your possession, please contact customer service.
See warranty for service contact.
Register your product today to receive further benefits:
Signs and symbols
Whenever used, the following signs identify safety and property damage messages and designate a level of hazard or seriousness.
READ THIS ENTIRE MANUAL, THE SAFETY SECTION AND ALL INSTRUCTIONS AND WARNINGS COMPLETELY AND CAREFULLY BEFORE USING THIS PRODUCT. FOLLOW ALL SAFETY INSTRUCTIONS AND WARNINGS TO AVOID HAZARDOUS SITUATIONS AND TO MAKE CORRECT USE OF THIS PRODUCT.
| This is the safety alert symbol. It alerts you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. |
| Product information Note on important information |
| Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. |
| Indicates a potentially hazardous situation, which, if not avoided, may result in minor/moderate injury. |
| Addresses practices not related to personal injury, such as product and/or property damage. |
![]() | Follow instructions for use |
![]() | Type BF applied part |
![]() | On |
![]() | Off |
![]() | Serial number |
IP 42 | IP class Device protected against solid foreign objects ≥ 1 mm and against water dripping at an angle |
Storage/Transport![]() | Permissible storage and transport temperature and humidity |
Operating | Permissible operating temperature and humidity |
Before using the device, read the safety notes carefully and follow the instructions exactly whenever using the device. Non-observance of the following instructions can result in injury or material damage. Store the instructions for use for future reference and make them accessible to other users. Any person using it on themselves must be over 12 years old. The product should only be used on children under 12 years old if supervised or assisted by an adult.
Battery Handling Safety Precautions
Notes on electromagnetic compatibility
This product is intended solely for household use in relieving itching or swelling caused by insect bites or stings through the use of heat. Do not use this product for any other purpose.
Many insect bites and stings result in painful and swollen sting and bite marks which can often cause severe itching. This insect bite healer offers effective relief for insect bites and stings through a targeted application of heat. As a result, the itching subsides and your symptoms improve; it is often noted that the area heals more comfortably.
1 x insect bite healer BR 60
2 x batteries, type AAA (LR03 1.5 V)
1 x instruction manual
Make sure the insect's stinger is no longer lodged in the skin. If needed, remove the stinger carefully. Using this device immediately after the insect bite/sting yields the best results. Waiting too long to treat the bite/sting will enable itching and swelling to start and the insect bite healer will only have a limited effect. Even if treatment cannot begin right away, do so as soon as possible, as this will usually still alleviate some itching and speed up the healing process.
Depending on the treated person's skin sensitivity, the heat from the device may feel unpleasant and cause slight skin redness and, in rare cases, irritated skin. If the heat function feels too hot, stop treatment immediately.
To shut the device off at any time, press and hold the Activation Button for about two seconds. In order to use the device again, slide the Power Switch to the "O" (Off) position and then to the "I" (On) position to switch the device back on.
If the device is accidentally left in the "I" (On) position and to prevent unintentional activation while inside a pocket or purse, the device will automatically switch off 2 minutes after use. In order to use the device again, slide the Power Switch to the "O" (Off) position and then to the "I" (On) position to switch the device back on.
Battery Levels
When the battery level becomes low, the Status LED will flash and the device will emit three short beeps. Replace both batteries as described in the "To Set Up" section.
Cleaning and Storage
Problem | Solution |
If the device does not turn on | Ensure the power switch is in the ON position. |
Make sure the batteries are not depleted. | |
If the device does not emit a sufficient heat pulse | Battery level is low; replace batteries. |
Device beeps three times and Status LED flashes | Battery level is low; replace batteries. |
Device is on and batteries replaced, but no heat pulse is emitted during treatment | Device has turned off automatically. Either the activation button was pressed for more than 2 seconds or it was not used for more than 2 minutes and the device turned off automatically. Slide the Power Switch to the "O" (Off) position and then to the "I" (On) position to switch the device back on. |
Device beeps five times and Ring Light flashes | Device may be damaged or faulty; Shut device off and wait 10 minutes before restarting. If the device does not begin working normally upon restart, contact Customer Service |
Type | BR 60 |
Max. temperature | 122°F ± 3.6°F (50°C ± 2°C) |
Operating Duration per Battery Set | Approx. 300 applications |
Power supply | 2 x 1.5 V AAA LR03 batteries |
Dimensions (L x W x H) | 3.85 x 1.4 x 0.8 in (98 x 36 x 20 mm) |
Weight (with batteries) | 1.65 oz (47 g) |
Functions | 2 application times (3s / 6s) |
Operating Ambient Temperature Range | 50 - 104°F (10 - 40°C) |
Storage Temperature Range | 14 - 122°F (-10 - 50°C) |
Operating and Storage Humidity Range | 30 - 85% |
Automatic device switch-off | 2 min after last application |
The serial number is located on the device or in the battery compartment. Subject to technical changes.
Limited Lifetime Warranty For Original Purchaser
For warranty service contact our customer service department at 1-800-5360366 or at info@beurer.com to provide a description of the problem.
For more information regarding our product line in the USA, please visit: www.shop-beurer.com
For Canada only:
Manufacturer:
Beurer GmbH
Söflinger Str. 218 89077 Ulm Germany
Distributed by:
Beurer North America LP
1 Oakwood Boulevard, Suite 255 Hollywood, FL 33020, USA www.shop-beurer.com
Questions or comments? Call our US-based customer service toll free at 1-800-536-0366.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the BR 60 and is the answer not in the manual?
Questions and answers