Sprout SOUNDLOOP Product Manual page 5

1. 1. WHAT'S IN THE BOX? WHAT'S IN THE BOX?
3. QUICK START GUIDE
CONNECTING VIA MICRO SD CARD
To play audio using a Micro SD card, firstly ensure Soundloop Party
Speaker is switched on. Insert your Micro SD card into the Micro
SD media input and Soundloop Party Speaker will automatically go
into Micro SD mode. The LED indicator light will be green to indicate
Micro SD mode and will play your media. Using the volume and play/
pause/answer buttons, you can directly control your music/audio
from Soundloop Party Speaker. When the media is paused, the LED
indicator will be flashing green.
CONNECTING VIA USB-A
To play audio using a USB-A drive, firstly ensure Soundloop Party
Speaker is switched on. Insert your USB-A drive into the USB-A media
input and Soundloop Party Speaker will automatically go into USB
mode. The LED indicator light will flash light blue to indicate USB mode.
Using the volume and play/pause/answer buttons, you can directly
control your music/audio from Soundloop Party Speaker. When you
press play, the LED indicator will be solid blue.
CONNECTING VIA 3.5MM AUX CABLE IN AUXILIARY MODE
To play audio using the aux cable, short press the power button only
after Soundloop Party Speaker is switched on. The LED indicator light
will flash green to indicate auxiliary mode. Next, connect the 3.5mm
aux cable from the Soundloop Party Speaker aux port to your device.
Soundloop Party Speaker will play the audio when you press 'play' on
your device.
Please note: When in auxiliary mode, Bluetooth connections will
disconnect from Soundloop Party Speaker. To reconnect Bluetooth
and stop auxiliary mode, short press the power button.
6
3. QUICK START GUIDE
CHARGING YOUR SOUNDLOOP PARTY SPEAKER
1. Open the port cover on the back of the speaker and connect
via the USB-C port to a USB-C power source, using the
included charging cable.
2. The LED battery indicator will flash from one to four LEDs to
indicate Soundloop Party Speaker is charging. The lights will
stop flashing once Soundloop Party Speaker is fully charged.
A full charge will take approximately 4 hours, depending on
the speed of the charger. Once charged, remove the charging
cable and replace the port cover.
Please note:
oundloop Party Speaker will announce "battery low"
S
when the battery level reaches approximately 15%.
LED BATTERY INDICATOR
4 white lights on: Battery 76 - 100%
3 white lights on: Battery 51 - 75%
2 white lights on: Battery 26 - 50%
1 white light on: Battery 0 - 25%
7