Workbed Elevation Bolts - Omtech USB 350l User Manual

7.6.2 Workbed Elevation Bolts

Lubrication Frequency: Every two weeks
Tools Needed:
• Cotton cloth
• White lithium grease
KEEP YOUR HAND CLEAR OF THE MOVING WORKBED WHILE APPLYING
GREASE.
1. Disconnect the engraver from power.
2. Open the rear access door to access the ball screws.
3. Clean any contaminated grease off the ball screws using a piece of cloth.
4. Apply some new lithium grease at the middle of the ball screws.
5. Move the workbed along its full stroke of motion along the ball screws to distribute the lubricant
evenly along the ball screws.
84