Beko QWIK-PURE 10 Installation And Operation Manual page 12

QWIK-PURE ®
2.5.5 Installation
Inappropriate assembly or electrical installation of the product and accessories may result in personal injury
and damage to property as well as impair operation.
For safe assembly and electrical installation, observe the following:
• Assemble the product and all the parts, accessories and materials used free of mechanical stress.
• Check all plug-type connections for a correct fit.
• Avoid stumbling risks by routing cables and hoses accordingly.
• Avoid mechanical strain on the cables.
• Fix and fasten hoses in such a way that they cannot flap around.
• Install inlet and drain lines as fixed pipes.
2.5.6 Maintenance
Improperly carrying out maintenance and repair work may result in serious injury or death.
For safe maintenance and repairs, observe the following:
• Before starting work, depressurise the pressurised product and accessories and secure them against
unintentional pressurisation.
• Before starting work, isolate the product and accessories from the power source and secure them against
being switched back on again unintentionally. Only use materials approved for the respective application.
• Use only suitable tools that are in proper working order.
• Only use cleaned pipes and hoses that are free of dirt and corrosion.
• Never use abrasive or aggressive cleaning agents or solvents which could damage the outer coating
(e.g. markings, type plate, corrosion protection, etc.).
• Never clean the device with hard or pointed implements.
• Use only the specified materials and media for cleaning.
• Observe statutory, local and in-house hygiene regulations.
• Pay attention to order and cleanliness during maintenance and repair work. Prevent contamination from
entering the opened product or accessories. Put dismounted components and accessories aside in a safe
place immediately after dismounting.
• After completing maintenance and repair work, remove all tools and cleaning agents used, as well as all
parts that are no longer needed, from the work area.
• Only dispose of the product and accessories when cleaned and freed of any media residue.
• Dispose of all components, parts, operating and auxiliary materials as well as cleaning agents
professionally and in accordance with all locally applicable legal requirements and regulations.
• Dispose of electrical and electronic components using a specialist disposal company or return them to
manufacturer.
12 | 68
Installation and operation manual