Sound; Adjusting The Sound - Aiwa XR-M88 Operating Instructions Manual

ADJUSTING THE SOUND
R
,,,.s. . . . .
/
'"\\
//
'
I '\ Ii I
VOLUME
}'
I
T-BASS
I
Qsurround
ENHANCING THE BASS SOUND
The T-BASS system enhances the realism of low-frequency
sound.
Press the T-BASS button on the remote control.
Each press on the T-BASS button lets you select one of the three
levels, or the off position.
~[~p-m,,,
7
'@GiiJ'EEiiiiP
(OFF)
m
Low frequency sound may be distorted when the T-BASS system
is used fora disc or tape in which Iowfrequencysound is originally
emphasized. In this case, cancel the T-BASS system.
L
BBE EQ
VOLUME
EQ (EQUALIZER)
ADJUSTING THE VOLUME
Press the VOLUME buttons.
The volume level is shown on the display for 4 seconds. It can be
set from O (minimum) to 30, and then MAX (maximum).
The volume is memorized even after the power is turned off.
However, if the power is turned off when the volume is set to
more than 21, it is automatically set to 21 the next time the power
is turned on.
ENHANCING THE TREBLE SOUND
The BBE system enhances the clarity of high-frequency sound.
Press the BBE button on the remote control.
Each press on the BBE button lets you select one of the three
levels, or the off position.
Lg]+m,,,
F
"m"-'
This system provides the following three different kinds.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
JAZZ: Accented lower frequencies for jazz-type music
Press the EQ button on the remote control.
I J
The graphic curve corresponding to the selected equalization
mode appears on the display.
Q SURROUND SYSTEM
The Q SURROUND system built into this system uses only two
speakers at the left and right to create an atmosphere that sounds
as if you are surrounded by two front speakers and two rear
speakers.
Press the Qsurround button on the remote control.
"QSURROUND ON" runs through the display, and the
"QSURROUND" indicator appears.
To cancel the Q SURROUND effect
Press the Qsurround button on the remote control.
"QSURROUND OFF" runs through the display, and the
"QSURROUND" indicator goes off.
The Q SURROUND system does not work in monaural mode.
When the Q SURROUND system is on, the sound may be
distorted at a higher volume. If this happens, turn the volume
down.
SOUND ADJUSTMENT DURING
RECORDING
The output volume and tone of the speakers or headphones may
be freely varied without affecting the level of the recording.
8
ENGLISH