Connecting Optional Equipment - Aiwa XR-M88 Operating Instructions Manual

CONNECTING OPTIONAL
EQUIPMENT
DIGITAL OUT
(OPTICAL)
MD IN
AUX IN
LINE OUT
u,
Iuly . u
Refer to the operating instructions of the connected equipment
for details.
The connecting cords are not supplied. Obtain the necessary
connecting cords.
Consult your local Aiwa dealer for optional equipment.
MD IN JACKS
This system can input analog sound signals from an MD player
or MD recorder through these jacks.
Use a cable with RCA phono plugs to connect an MD piayer/
recorder.
Connect the red plug to the R jack, and the white plug to the L
jack.
m
When using an MD recorder to record the sound of this system
(radio or CD), connect the MD recorder to the LINE OUT jacks.
This connection enables recording onto an MD in analog signal.
To record the CD playback sound of this system in digital signal,
connect the MD recorder to the DIGITAL OUT (OPTICAL) jack.
AUX IN JACKS
This system can input analog sound signals through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
(turntables, LD players, VCRs, TV, etc.).
Connect the red plug to the R jack, and the white plug to the L
jack.
When connecting a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
LINE OUT JACKS
This system can output analog sound signals for all functions
through these jacks.
Use a cable with RCA phono plugs to connect audio equipment.
Connect the red plug to the R jack, and the white plug to the L
jack.
m
DIGITAL OUT (OPTICAL) JACK
This system can output CD digital sound signals through this
jack. Use an optical cable to connect digital audio equipment
(digital amplifier, DAT deck, MD recorder, etc.).
Remove the dust cap @ from the DIGITAL OUT (OPTICAL) jack.
Then, connect an optical cable plug to the DIGITAL OUT
(OPTICAL) jack.
m
When recording the CD digital sound of this system using an
external digital equipment such as an MD recorder connected to
the DIGITAL OUT (OPTICAL) jack, proceed as follows to prevent
the beginning of the sound to be recorded from being cut.
1 Set the CD/tape unit to the CD playback pause mode.
2 Start recording on the connected equipment.
3 Start playback of the CD on the CD/tape unit.
When DIGITAL OUT (OPTICAL) jack is not being used
Attach the supplied dust cap.
SUPER WOOFER d JACK
Connect an optional powered sub woofer with a built-in-amplifier
to the jack.
Do not connect equipment to the LINE OUT jacks and AUX IN
jacks simultaneously.
Otherwise, noise is generated and malfunctions may occur.
--
~u ENGLISH