Adaptor Kit Installation C - Immergas Magis Combo 12 V2 I Instructions And Recommendations

The wall surface must be smooth, without any protrusions or recesses enabling access to the rear part. They are not designed to
be installed on plinths or floors (Fig. 1).
The appliance operates with R410A refrigerant gas.
This gas is ODOURLESS.
Pay the utmost attention
Strictly follow the instruction handbook of the Outdoor Unit before installation and
any type of operation on the chiller line.
Check the environmental operating conditions of all parts relevant to installation, referring to this booklet.
Installation of the appliance when powered by LPG or propane air must comply with
the rules regarding gases with a greater density than air (remember, as an example,
that it is prohibited to install plants powered with the above-mentioned gas in rooms
where the floor is at a lower quota than the country level).
If installing a kit or servicing the appliance, always empty the system's domestic hot water circuit first so as not to compromise
the appliance's electrical safety (Par. 2.9, 2.10).
Always disconnect the appliance from voltage and, depending on the type of operation, decrease the pressure and/or bring it to
zero in the gas and DHW circuits.
If the appliance is connected to a low temperature direct zone, it is necessary to check the necessary flow rate and possibly add a
relaunch pump.
It is just as important that the intake grids and exhaust terminals are not obstructed.
OK
ST.008705/000
Magis Combo 12/14/16 V2 I
1
9