Immergas Magis Combo 12 V2 I Instructions And Recommendations page 113

Parameter
ID
P 00 DHW max
P 01 Min C.H.
P 02 Central heating max
P 03 Relay 1 (optional)
P 04 Relay 2 (optional)
P 05 Relay 3 (optional)
P 07 External probe correction
P 21 Activation time
P 22 Increase time
P 23 Heat setpoint correction
P 24 Cool setpoint correction
Description
Defines the maximum heat output percentage of
the heat generator during the D.H.W. phase
compared to the maximum heat output available
Defines the minimum heat output percentage of
the heat generator during the C.H. phase com-
pared to the maximum heat output available
Defines the minimum heat output percentage of
the heat generator during the C.H. phase com-
pared to the maximum heat output available
See paragraph 1.41.
See paragraph 1.41.
See paragraph 1.41.
If the reading of the external probe is not accurate,
it is possible to correct it in order to compensate
any environmental factors
Temperature setpoint - Activation time correction 0 - 120 minutes
Temperature setpoint - Increment time correction
Allows to correct the heating mode demand
setpoint in presence of dispersions or system
decoupling circuits
Allows to correct the cooling mode demand
setpoint in presence of dispersions or system
decoupling circuits
ST.008705/000
Range
0 - 100 %
0 – P 02 %
0 - 100 %
0 ÷ 5
0 ÷ 5
0 ÷ 5
-9 ÷ 9 K
0 - 20 minutes
0 ÷ 10°C
0 ÷ 10°C
Magis Combo 12/14/16 V2 I
Customised
Default
value
100 %
0
85 %
0
0
0
0
20
5
0
0
113