Chicco Bravo Rubber Wheel Accessory Kit Instructions

PMS 2747 and PMS 186
INSTRUCTIONS:
Bravo Rubber Wheel Accessory Kit
IMPORTANT: Please also refer to the instructions
that came with your product.
TO REMOVE FRONT AND REAR WHEELS:
Remove the Front Wheels by pushing in on the
1
Release Button, just above the wheel (as shown). And,
at the same time, pull the Front Wheel off of the Stroller
Frame. Repeat for the other Front Wheel.
Remove the Pin from the Rear Axle using a flat blade
3
screwdriver, as shown. Discard the old Pin.
WARNING: Avoid serious injury or death to your child. Never
use your Bravo Stroller without Wheels PROPERLY attached!
You must read and understand the Rubber Wheel Accessory Kit
instructions and the instructions in the User Guide. If you do not
understand these instructions, DO NOT attempt to attach the
Wheels, STOP and call Chicco at 1-877-424-4226.
On one side of the stroller remove the Rear Wheel
2
Hubcap using a flat blade screwdriver, as shown. Discard
the old Hubcap.
Remove the Washer from ther Rear Axle. Discard the
4
old Washer.
1
Kit Includes:
Tools Needed: Flat Blade Screwdriver
(1/8" wide)
SS0014E_01