Advertisement
Quick Links
Assembly Instructions
Before you begin, please make sure all parts and proper quantities
are included. Any parts damaged during shipment must be reported
within 15 days of receipt. To report information regarding damage, to
purchase parts or accessories, or if you have any questions, please
contact us at:
www.spectrumfurniture.com
715-723-6750, 800-235-1262
Thank you for purchasing Spectrum products!
Note: Before proceeding with this installation, the display stand should be
fully-assembled on the table. The shroud works with one 37"-63" monitor.
(1) 0116552
shroud base plate
(4) 0106417
(10) 026059
1/4-20 x 1/2"
1/4" washer
carriage bolt
1. Remove monitor mount
If the monitor mount is installed, it will need to be removed from
the display stand before installing the shroud.
1. To remove the monitor mount, first remove the (4) 1/4-20 x
15mm JC bolts and back panel. Figure 1A.
Important
(2) 0116551
shroud
(10) 034195
1/4-20 wing nut
Display Shroud
for InVision Display Stand
monitor mount
display stand
95532
1/4-20 x 15mm
(4 required)
back
panel
Figure 1A
0116554R1 Page 1 of 5
4mm hex
wrench
7/16" or
adjustable
wrench
JC bolts
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Spectrum Industries 95532B
Summary of Contents for Spectrum Industries 95532B
- Page 1 Assembly Instructions Important Before you begin, please make sure all parts and proper quantities are included. Any parts damaged during shipment must be reported within 15 days of receipt. To report information regarding damage, to purchase parts or accessories, or if you have any questions, please contact us at: www.spectrumfurniture.com 715-723-6750, 800-235-1262...
- Page 2 1/4-20 locknuts 2. Remove the (6) 1/4-20 x 30mm JC bolts, and 1/4-20 locknuts and washers and set the mount aside. Retain all fasteners. Figure 1B. monitor mount plate 1/4-20 x 30mm JC bolts (6 required) Figure 1B 2. Install shroud base plate Two-vertical positions available 1.
- Page 3 2. Loosen the (4) 1/4-20 x 30mm JC bolts on the display stand laminate panel. Figure 2B. 3. Using the (4) keyholes in the shroud base plate, hang the shroud base plate on the loosened JC bolts. 4. Secure the shroud base plate and monitor mount plate to the display stand with (6) 1/4-20 x 30mm JC bolts, 1/4”...
- Page 4 4. Install monitor shrouds 1. Align the mounting holes of each monitor shroud with the shroud base plate. Figure 4. Each shroud will attach behind the shroud base plate (display stand-side). 2. Place the shroud slots over the base plate weld studs and move the shroud to the widest position first, then adjust to fit the monitor.
- Page 5 5. Route monitor wiring and install back panel 1. Route cords / wires to the monitor using the wiring tray and grommets. Wire routing options are shown in Figure 5. 2. After all wiring has been completed, install the back panel with (4) 1/4-20 x 15mm JC bolts and tighten securely.
Need help?
Do you have a question about the 95532B and is the answer not in the manual?
Questions and answers