Spectrum Industries 95532 Assembly Instructions

Assembly Instructions
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Note: Before proceeding with this installation, the display stand should be
fully-assembled on the table. The shroud works with one 37"-63" monitor.
(1) 0116552
Shroud base plate
(4) 0106417 (10) 026059
1/4-20 x 1/2" 1/4" Washer
Carriage bolt

1. Remove monitor mount

If the monitor mount is installed, it will need to be removed from the
display stand before installing the shroud.
1. To remove the monitor mount, first remove the (4) 1/4-20 x 15mm
JC bolts and back panel. Figure 1A.
Important
(2) 0116551
Shroud
(10) 034195
1/4-20 Wing nut
Display Shroud
for InVision Display Stand
Monitor mount
Display stand
95532
1/4-20 x 15mm
JC bolts
(4 required)
Back
panel
Figure 1A
0116554R2 Page 1 of 5
4mm Hex
wrench
7/16" or
adjustable
wrench