ROBLIN ARROW MURALE 900 Instructions For Installation Manual page 11

that the connector of the mains cable is correctly inserted in the socket placed on the side of the fan.
Before fitting the chimney to the canopy make the electrical connection as described in the section titled
ELECTRICAL. When the electrical connection has been made, test the lights and the fan motor.
c. Each chimney stack consists of two sections. Fit the upper sections (Fig. 1 - item 7a & b) first by
expand-ing the chimneys slightly to allow them to clamp around the bracket item 2 and secure the
chimney stacks to the brackets using the two M4 screws item 12c provided. Fit the lower chimney
sections by expanding the chimneys slightly to allow them from the top of the canopy to clamp around
the upper chimney sections.
IN THE RECIRCULATION MODE:
a. Fit the recirculation spigot R onto the upper chimney wall bracket using the same fixing screws (Fig.
2 item 2).
b. Connect the ducting 150mm (6 INS) not provided between motors item 6 and the recirculation spigot
and secure the connections with appropriate clamping rings or adhesive tape.
c. Remove the grease filters (see paragraph Maintenance) and the deflector item D fig. 8 being sure
that the connector of the feeding cable is correctly inserted in the socket placed on the side of the
fan. Before fitting the chimney to the canopy make the electrical connection as described in the
section titled ELECTRICAL. When the electrical connection has been made, test the lights and the
fan motor.
d. Insert the charcoal filter into the base of the motor housing and secure the filter with two metal secur-
ing straps item A as illustrated in Fig. 8.
e. Each chimney stack consists of two sections. Fit the upper sections (Fig. 1 - item 7a & b) first by
expand-ing the chimneys slightly to allow them to clamp around the bracket item 2 and secure the
chimney stacks to the brackets using the two M4 screws item 12c provided. Fit the lower chimney
sections by expanding the chimneys slightly to allow them from the top of the canopy to clamp around
the upper chimney sections.
4 OPERATION
A - EXTRACTION OR RECYCLING :Your cooker hood is supplied in the extraction mode. To use the cooker
hood in the recycling mode re-programme the hood as follows:
Starting in the recycling mode (the contaminated air passes into the hood through the grease filters and
the purifying activated charcoal filter and back out into the kitchen through grilles).
Press the '+' button (while the motor and lights are switched 'OFF') until the five LED lights will flash twice
to indicate confirmation that the cooker hood is in the recycling mode.
Reverting to the extraction mode (The cooker hood is ducted to the outside).
Press the '+' button (while the motor and lights are switched 'OFF') until the five LED lights will flash once
to indicate confirmation that the cooker hood is in the extraction mode.
GB
B - BASIC INSTRUCTIONS
Lighting
Press LED button 1 to switch 'ON' the lights and the LED will illuminate to confirm the lights are switched
'ON'.
GB
9