ROBLIN VISIERE 615 Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Quick Links

Visières
615 - 655 - 675 - 975
Operating Instructions
Mode d'emploi
Bedienungsanleitung
Gebruiksaanwijzing
Istruzioni per l'uso
Manual de instrucciones
Manual de instruções

Advertisement

Table of Contents
loading

Summary of Contents for ROBLIN VISIERE 615

  • Page 1 Visières 615 - 655 - 675 - 975 Operating Instructions Mode d’emploi Bedienungsanleitung Gebruiksaanwijzing Istruzioni per l’uso Manual de instrucciones Manual de instruções...
  • Page 2: General Information

    GENERAL INFORMATION This canopy hood is designed to be fixed to any rigid vertical surface, over a gas or electric hotplate and can be used either in the extraction mode (ducted to the outside) or in the recircu-lation mode (internal recycling). All cookers hood perform better when used in evacuation mode. During winter time it may be convenient to use the hood in the recycling mode to avoid heat loss from the kitchen.
  • Page 3: Operation

    2.3 - Wall mounting a - Drill two Ø 8 mm holes on the wall using the paper template, insert two rawl plugs and two 4.2 x 44,4 mm screws leaving 5 mm untightened. Open the metal grille panel, hook the hood on and fully tighten the screws.
  • Page 4 is clean, becomes visible from the outside of the metal grille. c - Foam synthetic filter (approx. 10 mm thick). It should be washed every two months in hot water using mild detergent and should be squeezed dry, not wrung out. Replace after 5 or 6 washings. d - Multi-layer metal filter.
  • Page 5: Conseils Concernant La Securite

    GENERALITES Cette hotte est destinée à être installée au mur, au dessus d’un plan de cuisson. Elle peut être utilisée en version évacuation (raccordement extérieur) ou recyclage (recyclage interne). Les meilleures performances s'obtiennent dans la version en évacuation extérieure. De toute façon il est conseillable d'utiliser la hotte dans la version recyclage pendant l'hiver pour éviter des dispertions de chaleur.
  • Page 6: Entretien Et Nettoyage

    b - Si le gabarit n'est pas disponible, faire deux trous Ø 8 mm, insérer chevilles et vis et procéder comme au paragraphe a. c - Pour une installation au mur avec des équerres (en option) s'en tenir aux instructions reportées sur le gabarit annexé.
  • Page 7 c - Filtre synthétique Il doit être lavé tous les 2 mois à l'eau tiède savonneuse; laisser-le sécher sur une source de chaleur à 40 C maximum après l'avoir tordu légèrement. Substituer-le après 5 ou 6 lavages. d - Filtre métallique multi-couche Il doit être lavé...
  • Page 8 4324204 02 - 091198...

This manual is also suitable for:

Visiere 655Visiere 675Visiere 975

Table of Contents