Undoing The Last System Restore; Resolving Software And Hardware Incompatibilities - Dell Inspiron 500m Owner's Manual

Click Next.
5
The Restoration Complete screen appears after System Restore finishes collecting
data and then the computer restarts.
After the computer restarts, click OK.
6
To change the restore point, you can either repeat the steps using a different restore
point, or you can undo the restoration.

Undoing the Last System Restore

NOTICE: Before you undo the last system restore, save and close all open files and close all
open programs. Do not alter, open, or delete any files or programs until the system restoration is
complete.
Click the Start button, point to All Programs
1
click System Restore.
Click Undo my last restoration and click Next.
2
Click Next.
3
The System Restore screen appears and the computer restarts.
After the computer restarts, click OK.
4
Enabling System Restore
If you reinstall Windows XP with less than 200 MB of free hard-disk space available, System
Restore is automatically disabled. To see if System Restore is enabled:
Click the Start button and click Control Panel.
1
Click Performance and Maintenance.
2
Click System.
3
Click the System Restore tab.
4
Ensure that Turn off System Restore is unchecked.
5
Resolving Software and Hardware
Incompatibilities
Windows XP IRQ conflicts occur if a device either is not detected during the operating
system setup or is detected but incorrectly configured.
Accessories System Tools, and then
So l v i ng P ro bl e m s 99