AEG CKB6541ACM User Manual page 13

Only the top oven works without the set
time.
The flashes when you connect the
appliance to the electrical supply, when there
was a power cut or when the timer is not set.
Press the or to set the correct time.
After approximately five seconds, the flashing
stops and the display shows the time of day
you set.
6. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Ignition of the hob burners
Always light the burner before putting on
the cookware.
WARNING!
Be very careful when you use open fire in
the kitchen environment. The
manufacturer declines any responsibility
in case of the flame misuse.
1. Turn the knob for the hob to the position
and push it down. When you push the
knob, the spark generator activates
automatically.
2. Keep the knob for the hob pushed for
equal or less than 10 seconds to let the
thermocouple warm up. If not, the gas
supply is interrupted.
3. Adjust the flame after it is regular.
WARNING!
Do not keep the knob pushed for more
than 10 seconds. If the burner does not
light after 10 seconds, release the knob,
turn it into the off position and try to light
the burner again after minimum 1 minute.
5.3 Changing the time
You cannot change the time of day if any
of the functions operates.
Press again and again until the indicator
for the Time of Day function flashes.
To set a new time, refer to "Setting the time".
If after some tries the burner does not
light, check if the crown and its cap are in
the correct position.
It is not possible to use the hob without
electricity.
If the burner accidentally goes out, turn
the knob to the off position and try to light
the burner again after minimum 1 minute.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut. It
is normal.
ENGLISH 13