CENTRAL CONTROL / COOLAUTOMATION
WIRING AND ADDRESS SET UP
NOTE
•
This only applies if there is more than one Condenser that will have a Central Controller or has
CoolAutomation.
•
Before Applying power to the Condenser
•
Make sure G1 and G2 are wired in daisy chain between outdoor units.
•
Set dip switches on outdoor units
•
This should done before start up even if Central Control or Automation is not being connected until a later date.
1 = OFF
0 = On
Dip switches are located on the
main board of the condenser
Address one is default, all dip switches on.
GR EE M ULTIPRO QUICK STA RT GUID E
| 6
Need help?
Do you have a question about the MULTIPRO GMV-V WL/C-T Series and is the answer not in the manual?