Basler Aviator Camera Link Installation And Setup Manual page 19

In the following step, you will be probing ports to see if aviator cameras are
attached. We suggest that you only probe the port(s) that you will be using to
communicate with an aviator camera. Probing a port that has a device other than
an aviator camera connected to it may change the configuration of the port and
may cause the device to stop operating correctly.
4. In this step, you will probe the checked port(s) to see if an aviator camera is connected to the
port. When the port is probed, the port configuration will be changed as required and then the
configurator will attempt to establish communication with any camera connected to the port.
To probe the checked port(s), click the Probe Selected Ports button.
(You can also probe an individual port by right clicking on a port ID in the list and clicking on
Probe this port from the menu that appears.)
5. The checked port(s) will be probed and if an aviator camera is detected, it will be indicated in
the tool as shown below. (This indicates that serial communication is working correctly.)
Click the Save button to save the port configuration and then click the Close button to close the
tool.
Basler aviator Camera Link
Software Installation
13