Invacare Motion Concepts Ultra Low Maxx TDX SP2 User Manual page 16

A raised
B lowered
outward (if mounted on right armrest) / inward (if mounted on
C
left armrest)
inward (if mounted on right armrest) / outward (if mounted on
D
left armrest)
Height and Angle Adjustment
The height / angle of the Maxx Resolve Remote Holder is adjusted via
two ball clamp assemblies on the swing away mechanism. The rear ball
clamp assembly is attached to the remote tube, on the front ball clamp
assembly the remote is mounted. Both ball clamp assemblies can be
independently adjusted to position the remote at the height and / or
angle that fits the user's needs.
Ball clamp assemblies mounted
upwards
1585725-M
Ball clamp assemblies mounted
downwards
When adjusting the angle of the ball clamp assemblies
upwards, the body of the swing away mechanism becomes
angled upward. This upward angle means that when the
remote swings outward (when mounted on the right armrest)
or inward (when mounted on the left armrest), it will swing-
away to a lower position. The opposite effect applies when the
angle of the ball clamp assemblies is adjusted downwards.
5mm Allen key
l
A
Angle Adjustment
1. Loosen screws A in each ball clamp assembly.
2. Pivot / Rotate the ball clamp assemblies to desired angle / height.
3. Tighten screws, when desired position is reached.
3 Setup
360°
Height Adjustment
16