TCL Alto 8 Plus Quick Start Manual page 16

Connections and setup
Before initial setup
Protect against power surges
•
Connect all components before you plug any power cords into the wall outlet
or power strip.
•
NEVER plug your TCL Roku TV into an outlet that is controlled by a wall
switch.
•
Turn off the TV before you connect or disconnect any cables.
•
Make sure all antennas and cables are properly grounded. Refer to the
Important Safety Instructions.
Safety information
•
Prevent TV from overheating by placing in an area with good ventilation.
•
Do not block ventilation holes on the TV. Position the TV so air can circulate
freely on all sides.
•
Do not stack objects on the TV.
•
If you place the TV on a stand, make sure you allow adequate ventilation.
•
If you connect an audio receiver or amplifier to the TV, place it on the top shelf
so the heated air will not overheat the TV.
Avoid audio interference
•
Position cables properly; insert each cable firmly into the designated jack.
•
Route all cables down one side of the back of the TV instead of straight down
the middle.
•
If your antenna uses 300-ohm twin lead cables, do not coil the cables.
•
Keep twin lead cables away from audio/video cables.
5