APRILIA SCARABEO 50 I.E - DEALER INSTRUCTION SHEET 2002 Instruction Sheet page 3

DEALER INSTRUCTION SHEET
6
Fit screws TCEI M 6x35 (6) of the wheel pin fork
clamp.
Screw (6) tightening torque: 8.85 ftlb (12 Nm).
Fit the brake gripper with the screws TEF
(2).
Screw (2) tightening torque: 16.96 ftlb (23 Nm).
SCARABEO 50 i.e.
M 8x30
Pag. 6
DEALER INSTRUCTION SHEET
3
2
FITTING THE BATTERY
CAUTION
Make sure the ignition key is in the
Place the battery into its housing.
First connect the positive cable (+ red) then the ne-
gative (- blue).
Use a neutral grease or vaseline to grease terminals.
Fit the tool tit holder and lower the saddle.
BLUE
SX DX
FITTING THE MIRRORS
IMPORTANT
" "
position.
Before fitting the mirrors, check the threading of
the nuts with pilers: the right nut is left-threaded
and the left nut right-threaded.
Tighten the nut with pilers M 8 (1) for the front brake
pump.
Position the ring nut (2).
Fit the mirror with rod and adjust as required.
Screw (1) tightening torque:
3
RED
Fit the protective guard (3), as shown in the drawing.
Carry out the same operations for the left-hand
mirror.
Pag. 3
SCARABEO 50 i.e.
2
1
14.75 ftlb (20 Nm)