APRILIA RS 125 - 1995 Manual page 37

If the adjuster is completely screwed or completely
unscrewed or if it is not possible to obtain a correct
idle stroke:
– unscrew the clutch inspection cover by means of a
screwdriver or a coin (Fig. 19);
– loosen the inside nut with the special spanner you
will find in the tool kit (2-Fig. 20);
– turn the adjusting screw with a screwdriver (3-Fig.
20) until you take up the slack completely;
– unscrew the above mentioned screw by giving it
half a turn, which corresponds to 3-4 mm of cable
stroke (1-Fig. 20);
– keeping the adjusting screw fast by means of the
screwdriver, tighten the nut with the special span-
ner;
– reassemble the clutch inspection cover.
a
If it is not possible to obtain a correct ad-
justment or if the clutch does not function
properly, contact your aprilia Official
Dealer.
Periodically lubricate the clutch cable with a suitable
lubricant, in order to avoid premature wear and corro-
sion.
Check the integrity of the cable: it must not present
flattened parts and the sheath must not be worn out
in any point.
Fig. 19
Fig. 20
37