ULTIMATE SPEED 378253 2110 Quick Start Manual

List of pictograms used
Please read the operating instructions!
Danger of suffocation! Keep the packaging out of reach
of small children.
Observe the warning and safety instructions!
Wash the covers by hand
Car Seat Cover Set
Introduction
We congratulate you on the purchase of your new product. You
have chosen a high quality product. Familiarise yourself with the
product before using it for the first time. In addition, please care-
fully refer to the operating instructions and the safety advice below. Only use
the product as instructed and only for the indicated field of application. Keep
these instructions in a safe place. If you pass the product on to anyone else,
please ensure that you also pass on all the documentation with it.
Intended use
Car seat cover set for driver and passenger seats, as well as back seats of
passenger cars (per included list of types).
Scope of delivery
4 x front seat covers (2 seating
covers and 2 backrest covers)
1 x cover for rear backrest
(separable into 1 to 4 pieces)
List of types
378253_2110_V1.0_uls_Autositzbezug-Set_content_GB_IE_NI_NL.indd 5 378253_2110_V1.0_uls_Autositzbezug-Set_content_GB_IE_NI_NL.indd 5
5 x covers for headrests
1 x cover for back seat
(not separable)
Do not use bleach
Do not dry in a tumbler
Do not iron
Do not dry clean
Safety instructions
Correct installation res. fastening of the seat covers to the vehicle is essential
to guarantee the safety of the user. Please pay attention to the following in-
formation when installing the seat covers:
DANGER OF SUFFOCATION! Keep
the packaging out of reach of small children.
Installation is permissible only in cars that are indicated in the list of types
on the packaging or in the enclosed, detailed list of types.
Correct assignment of the seat (driver and front passenger seat). The
covers are assigned by the marking "airbag" attached to the seat cover.
This marking must be attached to the outer side of the backrest
(see fig. 1.0). Be sure the seat cover is fitted correctly. The special seam
must match up with the seam on the original seat cover. A seat cover shif-
ting from use must be properly aligned.
Fig. 1.0
The fastening straps must be secured so as not to impair seat adjustments.
Do not secure the straps to cables or actuators.
Headrest inserts, adjustment levers / wheels for release of backrests or
armrests may not be covered with the seat cover. Allowances must be
made for appropriate inserts. Please observe the instructions given in
section "Installation".
Displaced seat covers must be repositioned. If this is no longer possible
due to a advanced state of wear and tear, the cover must be removed or
replaced.
Manipulation of the opening of the seat covers is not permissible
(no covering, sewing up or repairs by yourself).
This protective cover has been tested by DEKRA AUTOMOBIL GmbH.
CAUTION! If the seat covers are installed incorrectly, the proper extension
and inflation of the seat air bag cannot be guaranteed in the case of a
collision.
Installation
You need a pair of pointed scissors.
GB/IE/NI 5
21.02.22 07:52 21.02.22 07:52