Types Of Subscriber Accounts; Table 21 System Setting: Billing: Pms Configuration - ZyXEL Communications VSG-1200 User Manual

VSG-1200 User's Guide

Table 21 System Setting: Billing: PMS Configuration

LABEL
Charge Mode (only
for Port-Location
Mapping enabled)
Regenerate
password of static
account with PMS
checkout.
PMS Type
Revenue Code Enter a revenue code (between 01 and 99).
Description Enter the description for the revenue. Refer to the user's guide that comes with
Speed of PMS
Interface
Bits per second Select the speed of the PMS port connection. The default is 9600.
Apply

7.3 Types of Subscriber Accounts

After you have set up the subscriber authentication methods and billing profile(s), you need to
create subscriber accounts. There are two types of subscriber accounts: static and dynamic.
• For static accounts, refer to
• For dynamic accounts, refer to
82
DESCRIPTION
When you set up Port-Location Mapping, your VSG offers two billing modes:
Based on Room and Based on Subscriber.
Select Based on Room when location is important. If a subscriber disconnects
from one location and reconnects in another location, the VSG prompts for the
user name and password again.
Select Based on Subscriber to allow a subscriber to freely move between
different locations without prompting for user name and password.
Note: You must activate the port-location mapping feature. Refer
to Chapter 10, "Port-Location Mapping," on page
This feature is applicable when you select Scenario B with Built-in
Authentication in the Authentication screen (see
Select Enable to automatically generate a new password for the static account
when a subscriber checks out.
Select Disable to keep the password for the static account unchanged after a
subscriber checks out.
Select a PMS system and specify the fields below (if available). Currently the
VSG supports Micros Fidelio, Spectrum MK II, Marriott and Proprietary.
your PMS device.
Set the fields below to configure the PMS port settings on the VSG.
Note: Make sure the port settings are the same on the VSG and
the connected PMS device.
Data bits Specify the data bits.
Parity Specify the parity.
Stop bits Specify the data stop bits.
Click Apply to save the changes.
Chapter 8, "Static Subscriber Accounts," on page
Chapter 9, "Dynamic Subscriber Accounts," on page
Chapter 7 Billing Profiles and PMS Configuration
101.
Figure 29 on page 72).
83.
93.