2.2.4 Turning on the VSG
Connect the female end of the supplied power cord to the power socket on the back of the
VSG and the male end to an appropriate power source.
When the power source is turned on, the PWR LED on the front panel turns on.
2.2.5 Methods of Restoring Factory Defaults
You can erase the current configuration and restore factory defaults in two ways:
• Use the RESET button on the front panel of the VSG (press this button once). Use this
method for cases when the username, password and IP addresses of the VSG is not
known.
• Use the web configurator to restore defaults (refer to
Factory Defaults" on page
Note: All custom settings will be lost once you reset to the default settings.
Chapter 2 Hardware Installation and Connection
189).
VSG-1200 User's Guide
Section 23.8 "Reset the VSG to
37