Why Can't I Upload The Firmware And Configuration File Using Ftp Over Wan - ZyXEL Communications P-660HN-T1A Support Notes
P-660hn series 802.11n 1x1 wireless adsl2+ 4-port gateway
Hide thumbs
Also See for P-660HN-T1A:
- Manual (2 pages) ,
- User manual (372 pages) ,
- Wireless setup manual (4 pages)
Table of Contents
Advertisement
(2)You have disabled WWW/Telnet service in Web Configurator, Advanced
setup, Advanced -> Remote MGNT:
(3) WWW/Telnet service is enabled but your host IP is not the secured host
entered in Web Configurator, Advanced setup, Advanced -> Remote
MGNT:
(4)A filter set which blocks WWW/Telnet from WAN is applied to WAN node.
You can check by command:
wan node index [index #]
wan node display
4. Why can't I upload the firmware and configuration file using FTP over
WAN?
(1) When the firewall is turned on, all connections from WAN to LAN are
blocked by the default ACL rule. To enable FTP from WAN, you must turn
the firewall off or create a firewall rule to allow FTP connection from WAN.
The WAN-to-LAN ACL summary will look like as shown below.
Source IP= FTP host
Destination IP= P-660HN-T1A's WAN IP
Service= FTP TCP/21, TCP/20
Action=Forward
All contents copyright © 2010 ZyXEL Communications Corporation.
P-660HN Series Support Notes
25
Advertisement
Table of Contents
