ZyXEL Communications VSG1432-B101 - QUICK START GUIDE V1.10 Quick Start Manual page 7

2. Do one of the following for your Internet connection:
a. DSL WAN: Use a telephone cable to connect your VSG1432-
B101's DSL port to a telephone jack (or the DSL or modem jack on
a splitter if you have one).
b. ETHERNET WAN: If you already have a broadband router or
modem, use an Ethernet cable to connect the ETHERNET WAN
port to it for Internet access.
3. LAN: Use an Ethernet cable to connect a computer to a LAN port for
initial configuration and/or Internet access.
4. USB: Connect a USB (version 2.0 or lower) memory stick or a USB
hard drive for file sharing. Use a USB extension cable if the stick is
too big to fit.
5. POWER: Use the provided power adaptor to connect the POWER
socket to an appropriate power source. Make sure the power at the
outlet is on. After connecting the power adaptor, look at the lights on
the front panel.
• The POWER light blinks while your VSG1432-B101 starts up and
then stays on once it is ready.
• Each LAN light stays on if the corresponding LAN port is properly
connected and blinks when there is traffic.
• The ETHERNET WAN light stays on if the ETHERNET WAN port is
properly connected and blinks when there is traffic.
• The USB light turns on when your VSG1432-B101 detects a
connected USB device.
• The DSL WAN light turns on when your VSG1432-B101 has a DSL
connection.
VSG1432-B101 Series
7