Chamberlain SENTEX INFINITY Installation Instructions Manual page 15

CONNECT BUILT-IN MODEM/REMOTE
PROGRAMMING/MULTIPLE ENTRY
Multiple entry means hooking up more than one unit to a single
telephone line. This is a good choice, if you will be hooking up
only a few units, or in low traffic sites.
You may program the units from a remote location; for example,
you may use SPSWin (Chamberlain Programming Software for
Windows) on your personal computer. If you plan to remote
program your units:
• You must limit your multiple entry system to no more than two
(2) units.
• Each unit must have a unique programming access code
(password).
Chamberlain recommends hooking up no more than two units to
the same telephone line. Whenever one unit is using the line, the
other units will receive busy signals. If several visitors attempt
calls at the same time, most of the units will have to wait until the
line is free. Visitor complaints about delays can quickly become
annoying.
CONNECT OPTIONAL CLOSED CIRCUIT TELEVISION
(CCTV)
1. Plug the loose end of the coaxial cable into the monitor or
television.
NOTE: Maximum length of coaxial cable must not exceed 1000'
(max length based on monitor with .25 volt p-p. composite
signal sensitivity).
2. When the monitor or television is turned on, picture will appear.
A D D I T I O N A L F E A T U R E S
15