Troubleshooting - ZyXEL Communications PRESTIGE 2302RL Quick Start Manual

P-2302r series voip station gateway
Hide thumbs Also See for PRESTIGE 2302RL:
Table of Contents

Advertisement

5 Troubleshooting

PROBLEM
None of the LEDs turn
on when you connect
the Prestige's power.
Cannot access the
Prestige from my
computer.
Cannot access the
web configurator.
Cannot access the
Internet.
There is no dial tone.
The dial tone beeps
(pulses).
I can't make calls.
5.1 Set Up Your Computer's IP Address
This section shows you how to set your Windows NT/2000/XP computer to automatically get an IP address.
This ensures that your computer can with your Prestige. Refer to your User's Guide for detailed IP address
configuration for other Windows and Macintosh computer operating systems.
1 In Windows XP, click start, Control Panel. In Windows 2000/NT, click Start, Settings, Control Panel.
2 In Windows XP, click Network Connections. In Windows 2000/NT, click Network and Dial-up
Connections.
3 Right-click Local Area Connection and then click Properties.
CORRECTIVE ACTION
Make sure that you have the correct power adaptor connected to the Prestige and an
appropriate power source. Make sure that the power source is turned on. Check all cable
connections.
If the LEDs still do not turn on, you may have a hardware problem. In this case, you
should contact your local vendor.
Check the cable connection from your computer to the Prestige.
Make sure your computer's IP address is in the same subnet as the Prestige's IP address
(see
Section 5.1 on page
Make sure your computer's Ethernet adapter is installed and functioning properly.
If the Prestige's IP address has changed, then enter the new one as the URL.
Use Internet Explorer 6.0 and later or Netscape Navigator 7.0 and later with JavaScript
enabled.
Make sure you enter the password correctly (the field is case sensitive).
If you've changed the Prestige's password and forgotten it, use the RESET button. Press
the button in for about 10 seconds (or until the PWR LED starts to blink), then release it.
It returns the Prestige to the factory defaults (password is 1234, LAN IP address
192.168.1.1 etc.; see your User's Guide for details).
Verify the Internet connection settings in the wizard. Make sure you entered the correct
user name and password if you are using PPPoE.
Check the telephone connections.
You can test the telephone wire by using it to connect a telephone to a regular telephone
outlet and checking for a dial tone.
Make sure you have the wizard screens properly configured.
You can also check the Prestige's IP addresses and SIP account 1's registration status in
the Maintenance Status screen. The dial tone will be steady (and you should be able to
make calls) after the SIP account is registered.
P-2302R Series
10).
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prestige p-2302rPrestige p-2302rl

Table of Contents